Setting up and connection
FKS 250-1300 | Version 1.04
11
7
Setting up and connection
7.1 Requirements for the installation site
The panel saw must be set up stable on a level and firm
ground. It is important to ensure that there is enough
freedom of movement to work. The site should meet the
following criteria:
- The substrate must be level, firm and vibration-
free.
- Altitude of the workplace: max. 1000 m;
- Max ambient temperature: 40 ° C
- Min ambient temperature: 5 ° C
- Relative humidity of ambient air: 30% to 95%.
- The substrate must not let any lubricant through.
- The installation or work area must be dry and well
ventilated.
- Do not operate machines that cause dust and
chips near the machine.
- There must be sufficient space for the operating
personnel, for material transport as well as for ad
-
justment and maintenance work.
- The site must have good lighting.
- There must be a suction device with min. 570 m3 /
h extraction capacity, min. 20 m / s flow velocity at
the suction connection; Hose diameter 100 mm,
max. Hose length 4 m.
- Attach the machine to the ground and fix the ma
-
chine feet with expansion screws.
7.2 Setting up the panel saw
Use the following steps to make the machine operatio
-
nal:
Assembly of the sliding table
Step 1: Place the sliding table on the saw and release
the middle nut (Fig.6) of the guide.
Fig. 6: Guide carrier sliding table
Step 2: Insert the sliding table into the sliding carrier at
the front and rear of the saw and tighten the pre
-
viously loosened nut.
Fig. 7: Mount the sliding carrier
Assemble workbenches
Step 1: Screw the angle for the assembly of the side ex
-
tension table with 4 hexagon screws and was
-
hers to the working table of the saw.
CAUTION!
Danger of injury due to a machine that is not stably er
-
ected!
Check the stability of the machine after placing it on
stable ground.
CAUTION!
Some metal parts can be sharp-edged. Check all me
-
tal parts to avoid injury.
CAUTION!
Pay attention to the weight of the machine!
The machine may only be set up by two persons.
Check the aid accordingly for sufficient dimensioning
and load capacity.
ATTENTION!
To ensure sufficient stability of the machine, it should
be screwed to the ground. There are 4 holes on the
machine housing for this purpose
ATTENTION!
The workbench is heavy. Worry
For safety's sake, sufficient aids and support.
Summary of Contents for 5902030
Page 31: ...Notes FKS 250 1300 Version 1 04 31 15 Notes ...
Page 32: ...www holzstar de ...
