Holzstar 5902030, Operation Instructions Manual

Page: 16 / 32

16 FKS 250-1300 | Version 1.04
Operation of the panel saw
8 Operation of the panel saw
Check if the machine is working properly before using
the machine for a single pass.
- Make sure that the electrical cables are not dama
-
ged so as to avoid injury due to electric shock
(electric shock).
- Check regularly whether the safety covers are
mounted correctly and are not damaged. Repair
damaged covers immediately or have them re
-
placed by a qualified person.
- Do not operate the device with the cover removed.
- Do not use saw blades that are distorted, broken or
dull.
- Always use the saw blade that is suitable for the re
-
quired work and that meets the machine specifica
-
tions. The tools must comply with EN 847-1: 2005.
- Replace blunt saw blades as soon as possible
because blunt saw blades can cause injury or da
-
mage.
- Never use the saw blades at higher speeds than
recommended by the manufacturer.
- Before replacing or adjusting the tools, stop all
functions of the machine and disconnect the plug
from the socket.
- Do not remove or otherwise interfere with safety
devices such as covers, limit switches.
- When handling parts, ask for help from a qualified
person about your options.
- It is not recommended to work on the machine du
-
ring a storm.
With the sliding table of the sliding table saw large-sized
workpieces can be cut, without the stresses that would
occur through sawing on a stationary table.
In addition, the saw can be used as a regular table saw
to cut smaller workpieces. The saw blade rotates on a
spindle and breaks through the wood, making a conti
-
nuous impact.
Sawing
Step 1: Slowly guide the workpiece towards the saw
blade and allow the saw blade to cut. It is not
necessary to force the material.
Step 2: Hold the workpiece firmly when feeding it to the
saw blade and use the table for support. Always
use a push stick and keep your hand away from
the saw blade.
For best results, the saw blade must be sharp and in
good condition. A damaged or worn saw blade should al
-
ways be replaced as soon as possible.
DANGER!
Danger of electrocution!
There is danger to life when in contact with live com
-
ponents. Switched on electrical components can
cause uncontrolled movements and lead to serious
injuries.
- Disconnect the power before starting adjustments to
the machine.
WARNING!
Risk of death!
There is danger to life for the operator and other per
-
sons if they do not adhere to the following rules.
- The panel saw may only be operated by a trained
and experienced person.
- The operator may not work while under the influ
-
ence of alcohol, drugs or medication.
- The operator must not work when he is tired or suf
-
fering from concentration-impairing illnesses.
- The panel saw may only be operated by one person.
Other persons must keep away from the work area
during operation.
VORSICHT!
Health hazard.!
Wood dust and chips can damage the lungs when
inhaled.
The machine may only be operated with a suitable
extraction system.
CAUTION!
Crushing!
Incorrect work on the machine can cause injury to the
upper limbs.
Wear ear protection!
Wear safety glasses!
Wear dust mask!
Wear safety shoes!
Wear protective clothing!