SAFETY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
21
SB163VH
Fold-out D
RILL
C
HUCK
P
ROTECTION
, which covers the drill chuck
used and the clamped tool in its rest position at the front and
on both sides, and which prevents the machine from being
started up when the protection is open.
A fixed guard protecting access to the motor / belt drive.
12.4
General Safety Instructions
To avoid malfunctions, damage and health hazards when working with the machine, in addition to
the general rules for safe working, the following points must be observed:
Before start-up, check the machine for completeness and function. Only use the machine if
the guards and other non-parting guards required for machining have been fitted, are in
good operating condition and have been properly maintained.
Choose a level, vibration-free, non-slip surface for the installation location.
Ensure sufficient space around the machine!
Ensure a clean working environment and sufficient lighting conditions at the workplace!
Remove all adjustment tools or spanners before switching on the machine.
Only use perfect tools that are free of cracks and other defects (e.g. deformations).
Make sure that the on/off switch is in the "off" position before switching on the machine.
Keep the area around the machine free of obstacles (e.g. dust, chips, cut workpiece parts
etc.).
Check the strength of the machine connections before each use.
Never leave the running machine unattended. If necessary, stop the machine before
leaving.
Do not reach past the running spindle, but only clean the machine when the drilling
spindle is at a standstill.
The machine may only be operated, serviced or repaired by persons who are familiar with
it and who have been informed of the dangers arising during this work.
Ensure that unauthorized persons maintain a safe distance from the machine and keep
children away from the machine.
Wear suitable protective equipment (eye protection, ear protection, safety shoes) and
close-fitting protective clothing, but never loose clothing, ties, jewellery, etc. - danger of
being drawn in!
Hide long hair under a hair protector.
Always work with caution and do not use excessive force.
Do not overload the machine!
Do not work on the machine if you are tired, lacking concentration or under the influence
of medication, alcohol or drugs!
Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
12.5
Electrical Safety
Make sure that the O
N
/O
FF
switch is in the O
FF
position before connecting the machine to
the power supply.
Ensure that the unit is earthed.
Only use suitable extension cords.
Always shut down the machine before carrying out any conversion, adjustment,
measuring, cleaning, servicing or maintenance work and always disconnect it from the
power source for servicing or maintenance work. Before starting any work on the machine,
wait until all tools or machine parts have come to a complete standstill and secure the
machine against unintentional/unauthorized reconnection.
Proper plugs and suitable sockets reduce the risk of electric shock!
A damaged or tangled cable increases the risk of electric shock. Handle the cable carefully.
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from
heat, oil, sharp edges or moving parts.
Use of the power tool in a humid environment is only permitted if the power source is
protected by a residual current circuit breaker.
Do not use the power tool if it cannot be switched on and off with the ON/OFF switch..
