Holzmann SB 163VH, User Manual

Page: 28 / 38

TROUBLESHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 28
SB163VH
16.3 Storage
N O T E
Improper storage can damage and destroy important machine parts. Store packed or
unpacked parts only under the intended ambient conditions!
In the event of a prolonged interruption of operation or shutdown, clean the machine thoroughly
and store it in a dry environment protected from frost and other weather conditions!
16.4 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options
available.
If you buy a new machine or an equivalent device from your specialist dealer,
he is obliged in certain countries to dispose of your old machine properly.
17 TROUBLESHOOTING
W A R N I N G
Danger due to electrical voltage! Handling the machine with the power supply up
can lead to serious injuries or even death. Always disconnect the machine from the
power supply and secure it against unintentional or unauthorized reconnection before
carrying out any troubleshooting measures.
Many potential sources of error can be excluded in advance if the machine is connected properly
to the mains supply.
If you are unable to carry out necessary repairs properly or do not have the required training,
always consult a specialist workshop to rectify the problem.
Fault Possible Cause Trouble Shooting
motor does not run
 incorrect mains connection
 have checked by a
specialist
 switch defective
 exchange
 motor defective
 exchange
 safety devices are active
 check E
MERGENCY
O
FF
switch and switches in
the V-belt cover / spindle
guard (open?)
unusual operating noise  incorrect V-belt tension  adjust the V-belt to the
correct tension. Pressure
test with finger (1cm play)
drill is decentered/running
unbalanced/wobbles
 drill chuck eiert
 tap the drill chuck with a
wooden or rubber hammer.
 spindle is worn out
 replace spindle or ball
bearing
 clamping jaws are defective
 replace drill chuck
drill smokes  excessive friction Drill material
 ratio speed/material
 use lubricant
 too high a speed, reduce!
motor running, but no
rotation or weak drilling
performance
 lack of power transmission from
V pulleys to V belts:
 belts too loose
 belt contaminated with lubricant
 check belt when worn:
replace. Otherwise tighten
the belt.
 clean and dry belts