22
INSTALLATION INSTRUCTIONS
Mounting the Controller
Install the controller near a 240 VAC outlet. Preferably located in a house,
garage, or exterior electrical cubicle. For ease of operation, eye level placement is
recommended. Ideally, your controller location should not be exposed to rain or areas
prone to flooding or heavy water.
This inbuilt controller comes with an internal transformer and is suitable for
outdoor
or indoor
installation. The housing is designed for outdoor installation but the plug
needs to be installed in a weatherproof socket or under cover.
Fasten the controller using the key hole slot positioned externally on the top centre
and the additional holes positioned internally under the terminal cover.
Electrical Hook-up
WARNING:
1. All electrical work must be carried out in accordance with these instructions
following all applicable local, state and federal codes pertaining to the country of
installation.
Failure to do so will void the controller’s warranty.
2. Disconnect mains power supply before any maintenance work to the controller or
valves is undertaken.
3.
Do not attempt to wire any high voltage items yourself, i.e. pumps and pump
contactors or hard wiring the controller power supply to the mains. This is
the field of a licensed electrician. Serious injury or death could result from
improper hook up. If in doubt consult your regulatory body as to what is
required.
Field Wiring Connections
PREPARATION
1. Prepare wire for hook-up by cutting the wires to the correct length and stripping
approximately 0.25 inches (6.0mm) of insulation from the end to be connected to
the controller.
2. Ensure terminal block screws are loosened sufficiently to permit easy access for
wire ends. Insert stripped wire ends into the clamp aperture and tighten screws.
Do not over tighten as this may damage the terminal block.
Summary of Contents for DIAL EZY GARDENER
Page 8: ...6 SPARE WATERING PLANNER 5 6 ...
Page 34: ...32 SPARE WATERING PLANNER 5 6 ...
Page 35: ...33 SPARE WATERING PLANNER 5 6 ...