BA_PH_245-20_EN_15-22.docx
52
16.6
Extendable Frame Support
Figure 48: Clamping lever for extendable frame support
The table top with dimensions 1100 x 760 mm
can optionally be equipped with an extendable
frame support (instead of the rigid standard
frame support).
•
Toral length approx. 1375 mm
•
Extension depth approx. from the centre
of the milling spindle.
•
Guided in separate bearing blocks at the
side of the machine table.
The table is clamped by means of the two star
grips (
K
) which are located on the left and right
side of the table below the extension rods.
The article number, table extensions and other table systems can be found in section
Table Systems
“.
16.7
TM 100 - RFID based Machine Access Control System
Figure 49: TM 100 Machine Access Control System
The TM 100 key system offers the highest level
of security. With the user data bank, only au-
thorised personnel can start the machine by
using a personalised RFID key.
Included is the TM 100 system with master key
(red) for administrator access and four user
keys (blue) for authorised persons who are al-
lowed to work on the machine.
Additional user keys can be ordered.
The article numbers of the system and supplementary accessories are listed in section
16.8
Calibration Unit “Zeromaster”
Figure 50: Zeromaster
With the Zeromaster it is possible to measure
the effective cutter height and to reference
the machine incrementally to this value. This is
very helpful to calibrate the tool height or the
zero point of the tool quickly and easily.
The procedure for using the Zeromaster is de-
scribed in detail in section
The article number can be found in the section
“Technical Extensions”.
K
