BA_PH_245-20_EN_15-22.docx
41
13.3.6
Calibrate Cutter Height with Zeromaster (Option)
With the optional PANHANS "Zeromaster" calibrator, the display "A3" is semi-automatically calibrated to the
incremental zero point of the upper edge of the cutter (related to the upper edge of the table top). This calibra-
tion procedure does not refer to the spindle, but always to the currently clamped cutter. Therefore, this process
must be carried out via the incremental height indicator.
The incremental zero point with the Zeromaster calibrator may only be set when the spindle
resp. cutter is stationary!
Important:
First position the tilt axis exactly to 0.0° via tilt adjustment and display
“
A1
”
.
•
Now take the Zeromaster out of the tray on the side of the machine.
Figure 25: Calibrate cutter height with Zeromaster
•
In manual inching mode (section
press the
“
–
“ button
down until cutter is be-
low the level of the table top edge.
•
Place the Zeromaster on the tabletop (see
figure). The rear part must rest on the table
and the front part must protrude into the ta-
ble opening.
•
Press button
“
TA3
”
for at least 3 seconds
→
The display”
A3
”shows
“
CAL
”
.
•
Now move the cutter upwards step by step
with the “
P
” and “
+
” buttons in manual inch-
ing mode until it touches the Zeromaster.
→
When the cutter comes into contact with the Zeromaster, the zero point is transferred to the display “
A3
”
.
•
The height adjustment may have a slight overtravel when the cutter touches the Zeromaster
→
However, the correct zero point is taken at the table top edge.
•
Release the
“
P
” and “
+
” buttons
as soon as the value has been adopted in the display.
•
The display indicates the current measurement of how far the cutter is above the table top edge.
•
After use, place the Zeromaster back in the designated tray (refer to
During the calibration process, please always ensure that the spindle does not collide with the in-
sert rings in the table top or other obstacles!
13.3.7
Storage Tray for the Zeromaster
The storage tray for the Zeromaster is located on the right side of the machine behind the milling table.
Figure 26: Storage tray for the Zeromaster
After use, place the Zeromaster back in
the tray, as it must always be insulated
when not in use. Otherwise the height
adjustment can be misadjusted uninten-
tionally!
As the shelf is made of plastic, uninten-
tional height adjustment is effectively
prevented.
Zeromaster
Table top edge
Cutter
