BA_PH_245-20_EN_15-22.docx
47
14.4
Handwheel Adjustment
Figure 37: Digital handwheel
The fence type 216 is equipped with the digital handwheel “DE10”.
Via the LCD display, the total fence position can be read off directly
at the fence with an accuracy of 0.1 mm.
Absolute / incremental measurement switchover:
•
With the button you can switch between incremental
and absolute measurement.
•
When the incremental measurement is active, the handwheel
display also shows the symbol .
Please note: To compensate for the spindle play of the
fence, the dimension should always be approached from
behind (loop). To do this, move approx. 4 -5 mm beyond
the target position and then back to the desired position.
14.4.1
Handwheel Battery Change
Operating times and the ambient conditions influence the battery life. The battery life is approx. 8 years. As
soon as the battery symbol appears in the display, the battery should be replaced.
Figure 38: Battery change
(
1
) Battery compartment
(
2
) Battery (polarity:
–
points upwards |
+
points downwards)
The stored position value is retained when the battery is changed.
IMPORTANT: Observe polarity!
•
Incorrect polarity when inserting the battery leads to
loss of the position value.
•
Otherwise, the display unit must be recalibrated. For
this, please contact our customer service under the
telephone number 0049 7571 / 755 - 0.
14.4.1.1
Preparation
Have the replacement battery ready
→
3 V lithium button cell, type
CR2477
.
14.4.1.2
Disassembly
1.
Pull out the battery compartment (
1
) to the front.
2.
Remove the old battery (
2
) from the compartment.
3.
Dispose of old battery.
Fire, explosion and burn hazard! Never recharge the battery used in the digital handwheel or
expose it to temperatures above 85° C.
Used batteries must not get into fire, water or groundwater and must not be disposed of in
household waste. Collect batteries and dispose of them in an environmentally friendly manner
(e.g. in a battery collection container or at a battery collection point).
14.4.1.3
Assembly
1.
Insert the new battery (
+
must point downwards!)
2.
Push the battery compartment (
1
) back in completely and check the function of the unit.
Further documents:
The original operating instructions for the “DE10” unit can be found via the following link:
https://www.siko-global.com/adbimage/2642/asset_original/installation-instructions-de10.pdf
2
1
