14
Ill. 2:
Sash lock
1.1.0
2.1
Upper door cross-rail
30.5“
1
2.2
Upper Section Right Vertical Door Support with holes for hinges
46.3“
1
2.3
Left Vertical Door Support with 2 holes at bottom
46.3“
1
2.4
Door Crossbeam with large hole for door handle
28“
1
3.1
Vertical Support with sash lock holes
29“
1
3.2
Top Crossbar with VK T-holes
30.6“
1
3.2.1 Lower Section Rectangular tube VK T 30/30 as door stop
28“
1
3.2.2
Seal 2mm
23 feet
1
3.2.3
Distance blocks 4 mm (yellow)
3“
2
3.2.4
Connecting screw for top part of lower door
3,5 x 32(0.1“ x 1.25“) 2
3.3
Right Vertical Support with hinge holes
29“
1
3.4
Bottom Crossbar
30.6“
1
1.1.0
Connecting screw
3,5 x 32 (0.1“ x 1.3“) 6
1.1.1
Connecting screw
4,8 x 50 (0.2“ x 2.0“) 4
1.0
Aluminum Corner Connectors with a hole on side
2“ x 2“ x 0.4“ 6
length
number
designation
profile
Pos.
Ill. 1:
Upper Door Section:
See Ill. #1
Lay out the profiles according to the drawing on the left.
Insert the Aluminum Connectors (#1.0) into the Vertical
Supports (#2.2 and 2.3) so that the holes in the Connectors
line up with the holes in the Vertical Supports. After they are
lined up the profiles are screwed together with the screws
going through the screw channels in the Top Crossbar (#2.1).
Use the sheet metal screw 3.5 x 32 (0.15“ x 1.25“). See
Picture.
Next, place the large Lower Crossbeam (~ 4“ wide) with
doorhandle hole (#2.4) and screw it together with the sheet
metal screws 4.8 x 50 (0.2“ x 2“). Two screws each go on
both sides - as shown.
Lower Door Section:
See Ill. #2 & #3
Assemble the bottom half of the door the same way as the
top half. Then press the strip of sealer material into the
intended sealing grooves. Always cut the seals a bit longer
and then press them so there is slightly too much rubber seal
on each end. Over time temperature fluctuations will slowly
shorten this excess rubber seal. See Ill. #3
Lie the rectangular tube 1.25“ x 1.25“ x 28“ on top of the Top
Crossbar and insert the yellow spacers (#3.2.3) between the
Top Crossbar and the Rectangular Tube (#3.2.1) (See Ill. 3).
Next, attach the Rectangular Tube to the Top Crossbar using
the long screws (3.5x38), screwing them upwards through
the Top Crossbar (#3.2), as shown in Ill. #2.
Next, place the two black caps
(1.25“ x 1.25“) on each end of
the Rectangular Tube.
Ill. 3:
3.2.4
3.2.1
3.2.3
3.2
3.2.2
4.8x23
3.5x32
Part of the total parts list
Parts
list
for
divided
revolving
door
