9
Step 13: Place rest of Roof Glazing Panels:
Now place the rest of the large Glazing Panels (remember that if you are installing a second
Roof Window) you must place this in one of the other sections as you prefer). When you have
completed the last section attach the back wall.
Step 14: Connection of the Back section to the Side Floor Profiles & to the Roof Beam:
(also refer to step 5)
Now attach both Side Floor Profiles (#1.2) to the back section by means of inserting the aluminum-
corner connectors with recessed screws while at the same time sliding the Curved Corner Profiles
(#2.1) in to the Side-Floor Profiles, tighten the recessed screws. (see picture on previous page).
Next
tread the top ends of each of the Curved Corner Profiles onto the Roof Beam and attach the
Roof Beam Cover Plate with screws (4.2 x 13mm).
Step 15: Glazing of Front Wall:
First insert the bottom two Gazing Panels (all most square), one on either side of the door frame
(suggestion: remove the top Crossbar of the Door Frame - to allow you more manouvering space -
you can slide the Door Frame Uprights towards the center). If you have bought the RIGA shelving, you
must slide one M6 x 16 Hexagon Bolt in to each of the Front Crossbars. Than set the Front Crossbars
(#1.4) on top of the bottom Glazing Panels. Then place on top of each Crossbar a Glazing Panel with
the curved edges, making sure the side with the UV-filter in facing outwards (as always). Now
permanently attach the Crossbars to the outersupports (Curved Corner Profiles and Door Frame),
using screws: 4.8 x 45mm (0.2“ x 1.75“). See picture on the left.
Next, insert the small triangular Glazing Panel above the Door Frame (you will have to remove the Top
Crossbar - if you haven‘t already done so). Before, you put the top crossbar back and bolt it in place,
make sure the triangular Panel is inserted such that the bottom edge is perfectly horizontal (if you like,
use a level) and that the top corners at each of the ends of the Crossbar touch the Curved Corner
Profiles.
Step 16: Glazing of the Back Walls
:
Follow step 15 to insert the Glazing Panels on each side of the vertical uprights. Than place the
center Galzing Panel in the bottom of the „door“ opening and cap with the Back Wall Crossbar
(#1.9). Make sure you insert 3 Hexagon Bolt (M6 x 16mm) in the channel of the Crossbar. Using
the Round Mounting Plates with 4 holes attach each side of the Crossbar to the „door“ frame -
using the bottom Hexagon Bolts in the door frame. The 3rd Hexagon Bolt in the Crossbar will be
used to attach the Rear Window Opener to.
Next, insert the triangular Panel above the „door“ frame. Same process as in Step 15.
