Hokkaido HCND 261 X, User Manual

Page: 14 / 40

- 14 -
Outline of the remote controller’s buttons
INFRARED REMOTE CONTROLLER
SET TEMPERATURE
ON/OFF
SWING
AIR FLOW
SLEEP
LAMP
HOLD
MODE
FAN SPEED
TURBO
TIMER
NOTE: When TURBO operation is selected, room temperature is not controlled. If you feel the
room temperature is too cool or too heat, please cancel TURBO operation.
Transmission procedure
When each button on the remote controller is pressed with the remote
controller pointing toward the air conditioner Unit, signal is sent.
When the signal is received correctly, the receiving sound is emitted from
the Unit.
These buttons are for setting
room temperature.
If you press “+” button, set
temperature increases by steps
of 1°C.
If you press “-” button, set
temperature decreases by steps
of 1°C.
The room temperature range is
from 16°C to 32°C.
(Temperature is automatically set
at 25°C and unadjustable in AUTO
mode and DRY mode).
This button is used for start and
stop operation.
This button is used for selection
of the left/right air flow direction:
whenever pressed, the flap will
swing or fix (HKED 531, 611 X
Models).
Press this button to choose the
up/down air flow direction you
would like to set:
• natural fl ow: is displayed.
• s wing: is flashing.
• fix ed wind air: is displayed.
- It would be automatically set
at fixed wind air flow direction in
DRY mode.
This button changes to SLEEP
operation.
Press this button to lock or unlock
the keyboard.
Press this button to light on/switch
off the display.
This button changes the
operation mode:
• AUTO
• COOL
• DR Y
• HEA T
• F AN.
Press this button to change
fan speed:
• LO W ( is displayed)
• MED ( is displa yed)
• HIGH ( is displa yed)
• AUTO ( is flashing).
In COOL and HEAT modes,
this button changes to TURBO
operation.
(It does not work in AUTO,
DR Y and F AN modes).
This button is used to set TIMER ON
or TIMER OFF .
MODE
FAN SPEED
TURBO
SWING
TIMER
HOLD
AIR FLOW
SLEEP
LAMP