Wheel Torque Requirements
Be sure to use only the fasteners matched to the cone angle of your wheel
(usually 60° or 90°). The proper procedure for attaching your wheels is as
follows:
1. Start all bolts or nuts by hand to prevent cross threading.
2. Tighten bolts or nuts in the sequence shown for wheel torque
requirements.
3. The tightening of the fasteners should be done in stages. Following
the recommended sequence, tighten fasteners as shown in the chart
below.
4. Wheel nuts/bolts should be torqued before first road use and after
each wheel removal. Check and re-torque after the first 10 miles, 25
miles and again at 50 miles. Check periodically thereafter.
Wheel Size
1st Stage
2nd Stage
3rd Stage
12"
20-25
35-40
50-75
13"
20-25
35-40
50-75
14"
20-25
50-60
90-120
15"
20-25
50-60
90-120
16"
20-25
50-60
90-120
16.5" x 6.75"
20-25
50-60
90-120
16.5" x 9.75"
55-60
120-125
175-225
14.5" Demount
Tighten Sequentially to
85-95
17.5" Hub Pilot Clamp Ring
& Cone Nuts
50-60
100-120
190-210
17.5" Hub Pilot 5/8" Flange
Nuts
50-60
90-200
275-325
Page
32
Summary of Contents for ODP 40
