HOGG & DAVIS ODP 40, Manual

Page: 8 / 74

ODP 40
4,000 Lb Drum Puller
- - 8 - -
© COPYRIGHT 2016 HOGG & DAVIS, INC
Setup on the Job
Setup of the unit
Position of unit
Position the trailer with the centerline
of the trailers inline with the pull.
Place the unit at a minimum of two
times the height of the first block.
Jack Stands / Outriggers
Actuate the rear outriggers to stabilize the trailer. Attempt to
level the trailer as much as possible. The outriggers have the
ability to raise the tires from the ground, but as a rule they
should be used to stabilize the load across all contact points on
the ground, i.e. Jack stands, tires, front tongue jack stand.
Tie Down/ Brake/ Chock
Chock all wheels and set brakes (if applicable). It should be
noted that a fully loaded trailer may exceed the tension
desired during the pull. As the pull progresses, the weight of the
trailer may increase or decrease, therefore proper securing
procedures should be followed during operation. This unit is
equipped with tie
– down eyes for staking to the ground and it
is recommended that the unit stay secured to the tow vehicle
whenever possible.