Page III
SAFETY INFORMATION
For your safety, read this manual thoroughly before operating the equipment.
The Aligner is intended for use by properly trained skilled automotive technicians. The safety messages
presented in this section and throughout the manual are reminders to the operator to exercise extreme
care when performing wheel alignments with this product.
There are many variations in procedures, techniques, tools, and parts for servicing vehicles, as well as
the skill of the individual doing the work. Because of the vast number of vehicle applications and potential
uses of the product, the manufacturer cannot possibly anticipate or provide advice or safety messages to
cover every situation. It is the automotive technician’s responsibility to be knowledgeable of the vehicle to
be aligned. It is essential to use proper service methods and perform wheel alignments in an appropriate
and acceptable manner that does not endanger your safety, the safety of others in the work area or the
equipment or vehicle being serviced.
It is assumed that, prior to using the Aligner, the operator has a thorough understanding of the vehicle
systems being serviced. In addition, it is assumed he has a thorough knowledge of the operation and
safety features of the alignment rack or lift, and has the proper hand and power tools necessary to per-
form wheel alignments.
When using your garage equipment, basic safety precautions should always be followed, including:
Read and understand all instructions.
1.
Care must be taken as burns can occur from touching hot parts.
2.
The socket-outlet (wall outlet) shall be located near the equipment and shall be easily accessible.
3.
Do not operate power tools or equipment with a damaged power cord or if the equipment has been dropped
4.
or damaged until it has been examined by a qualified serviceman.
Do not let electric cord hang over edge of table, bench or counter or come in contact with hot manifolds or
5.
moving fan blades.
If an extension cord is necessary, a cord with a current rating equal to or more than that of the equipment
6.
should be used. Cords rated for less than the equipment may overheat. Care should be taken to arrange the
cord so that it will not be tripped over or pulled.
Always unplug equipment from electrical outlet when not in use. Never use the cord to pull the plug from the
7.
outlet. Grasp plug and pull to disconnect.
Let equipment cool completely before putting away. Loop cord loosely around equipment when storing.
8.
To reduce the risk of fire, do not operate equipment in the vicinity of open containers of flammable liquids, such
9.
as gasoline.
Adequate ventilation should be provided when working on operating internal combustion engines.
10.
Keep hair, loose clothing, fingers, and all parts of body away from moving parts.
11.
To reduce the risk of electrical shock, do not use on wet surfaces or expose to rain.
12.
Use only as described in this manual. Use only manufacturer’s recommended attachments.
13.
ALWAYS WEAR SAFETY GLASSES. Everyday eyeglasses only have impact resistant lenses, they are NOT
14.
safety glasses.
Know and understand the proper operating procedures for all power tools used.
15.
Caution:
16.
Risk of explosion if any battery is replaced by an incorrect type. Dispose of used batteries according
to local and state government regulations.
IMPORTANT!! SAVE THESE INSTRUCTIONS
DO NOT DISCARD!!
Summary of Contents for Pro42
Page 1: ...Operators Manual Portable Imaging Alignment Systems with Pro42 ...
Page 2: ...Blank page ...
Page 8: ...Page 8 Table of Contents ...
Page 65: ...NOTES ...
