Page 3-48
Chapter III Operation
EZ Toe
This software routine is a an improved method of setting
front toe, making it easier to obtain straight steering
wheels. It also makes it possible to adjust toe with
the wheels turned at any angle left or right, an aide
when setting toe on cars with firewall mounted rack
and pinion units.
Use the following procedures:
1. Perform all alignment steps normally used to obtain
alignment readings. Correct any misalignment in
the rear as well as front caster and/or camber.
2. Select the EZ Toe icon from the Adjust screen.
3. Level the vehicle steering wheel, Select OK.
4. Steer the right wheel to the adjust position. Select
Next.
5. The next screen shows a meter indicating the
amount of toe change needed for the right
wheel.
6. Adjust the right tie rod until the meter needle is in
the green. Select Next after completion.
7. Follow the same procedures for the left wheel.
8. Select Next when the left toe adjustment is
made.
9. Return to the Front Readings screen and recheck
toe and steering wheel position.
NOTE: If using EZ Toe at a large turn angle, it will
be necessary to use the Steering Wheel Clamp to hold
the linkage steady at that position.
Summary of Contents for Pro42
Page 1: ...Operators Manual Portable Imaging Alignment Systems with Pro42 ...
Page 2: ...Blank page ...
Page 8: ...Page 8 Table of Contents ...
Page 65: ...NOTES ...
