5999.505-01C 12.06.2007 WM
2
10
4.3
Adjustment of the optical label scanner
Proceeding of the adjustment of the optical label scanner:
Switch on the Collamat 2600. Set the label scanner potentiometer to zero.
Pull the labelweb so that the gap is located below the marking 1 of the scan-
ner. Turn the potentiometer until the red LED on the scanner goes off. Con-
tinue pulling the labelweb until a label is located below the scanner. Continue
turning the potentiometer until the LED switches off again.
The optimum setting is at the center position of the two potentiometer settings
witch turned the LED off.
Remark:
If the setting of the optical label scanner is faulty, the gap between the
labels will not be detected. After the triggering of a labelling operation,
the labeler will stop after approx. 0.75 m of the labelweb.
For transparent labels, please use the mechanical label scanner.
Figure 7: Adjustment of the optical label scanner
Gap
LED
1
i
