7-4
●
Start operation
●
Continuous ejection of ink even though not printing is abnormal. If this occurs, stop ink ejection by pressing the
SHUTDOWN
→
No-cleaning stop .
TEST
START PRINTING
SHUTDOWN
SETTINGS
LOGIN
Shutdown Process Confirmation
No.051
CONFIRMATION
×
Shutdown will stop the ink jet.
Solution 1. To stop the ink jet, press <OK>.
2. To stop the ink without cleaning, press <No-cleaning stop>.
OK
Close
No-cleaning
stop
●
For a description of subsequent operation, see “7.1.2 When an error occurred at the start of operation”.
●
At ink ejection, ink may momentarily spurt out and soil the paper. However, this is normal.
Press No-cleaning stop .
Press SHUTDOWN .
Wait until the status changes from “Starting” to “Ready”.
●
When the temperature is low (approximately 20 C or lower), it may take longer than usual for the printer
to enter the “Ready” state.
●
Check the Ink pressure.If there is a difference of 0.010 or more from the standard value, adjust the
pressure to the standard value ± 0.002. Refer to Technical manual “6.9 Adjusting tha pressure”)
5
Input the print target detection signal and check whether or not the print state and
print description are correct.
●
If the print target detection signal is input when the status is “Ready”, the set print description is printed.
6
