2
1
2.4.3
Debug Board Jumper Switches
Table 2.2 describes a method for setting the EPROM selection jumper switch (J1) on the debugger board. For
details of a memory map during debug board connection, refer to 4. “Memory Map.”
Table 2.2 Setting the EPROM Selection Jumper Switch (J1)
Jumper
switch
Setting
Description
Debug board resources are assigned to area 0 on the SH7760 board as
shown below. (Factory setting)
- The EPROM mounted on the debug board is assigned to an address range from
h’00000000 to h’001FFFFF.
- The 8-bit LEDs mounted on the debug board are assigned to an address range
from h’00400000 to h’007FFFFF.
- The 16-bit LEDs mounted on the debug board are assigned to an address range
from h’00800000 to h’00BFFFFF.
- The flash memory of Solution Engine2 is assigned to an address range from
h’01000000 to h’017FFFFF.
J1
Debug board resources are assigned to area 0 on the SH7760 board as shown
below.
- The flash memory of Solution Engine2 is assigned to an address range from
h’00000000 to h’007FFFFF.
- The EPROMs mounted on the debug board are assigned to an address range
from h’01000000 to h’011FFFFF
- The 8-bit LEDs mounted on the debug board are assigned to an address range
from h’01400000 to h’017FFFFF.
- The 16-bit LEDs mounted on the debug board are assigned to an address range
from h’01800000 to h’01BFFFFF.
1
2
Pins 1 and 2: OPEN
1
2
Pins 1 and 2 are short-circuited.
Summary of Contents for SH7760 Solution Engine2
Page 3: ......
