E-25
Maintenance
Brush maintenance.
Remove the brush holder.
1
Detach the rotary brush and roller and remove dust.
2
Adjust the rotary brush and roller with the groove and attach them to their original positions.
3
Attach the brush holder.
4
Lever
Brush
holder
Rotary brush
Roller
Remove dust.
Groove
Tweezers
Scissors
Remove the dust tangled in the
groove using tweezers, etc.
Cut and remove dust tangled
in the rotary brush or roller
using scissors, etc.
Groove
Hole
Short shaft
Shaft
Hook
Flip over the power head and open the lever.
Remove the brush holder.
Adjust the rotary brush with the groove
and attach it to its original position.
Adjust the shorter shaft of the roller with
the hole and attach it to its original position.
Insert the hook.
Attach the brush holder.
Close the lever.
●
Do not use cleansers, bleach, etc. Doing so may cause discoloration, deformation, etc.
●
After washing with water, thoroughly air dry it before attaching it.
Drying it requires approx. 24 hours. (The drying time varies depending on the environment and season.)
Note
When attaching the brush holder, fasten the hook first. Failure to do so may cause damage.
Note
Remove excess water from the rotary
brush as well and swab it with a dry cloth.
Lean them against an object to
dry in the shade.
After drying, the
roller may fluff but it
can be used as it is.
Wash with water.
Shake to remove excessive water.
Thoroughly air dry.
The lengths of the
left and right shafts
of the roller are
different. Check
them before
attaching.
Note
To wash the rotary brush and roller with water
TS_PV-XC500.indd 25
TS_PV-XC500.indd 25
8/7/2015 10:24:45 AM
8/7/2015 10:24:45 AM
