Hitachi IR.LINK, User Manual, Page: 48 / 103

4 OPERATION
4-5
<Notes on installing in Windows® 7 (32-bit)>
Installing the S10V IR.LINK system in Windows® 7 (32-bit) operating system requires prior
logging onto the operating system with an appropriate Administrator account, which is the
Administrator account first created in the initial condition of your personal computer. When
you have so logged on, you can then double-click “setup.exe” that is stored in the DISK 1 folder
on the S10V IR.LINK System CD. When “setup.exe” is started, the dialog box as shown
below will appear. Click the Yes button to continue the execution of the setup program.
The S10V IR.LINK system cannot be installed on a per-user basis. To install the
S10V IR.LINK system successfully, the user must first log onto the operating
system with an appropriate Administrator account, which is the Administrator
account first created in the initial condition of your personal computer.
The S10V IR.LINK system may not be installed properly in any of the following
cases: 1) administrator permission is acquired by using User Account Control(*)
with a standard user account and 2) logon is made with an Administrator account
that has been created using User Account Control with a standard user account.
If you make a logon with a user account that is different from the one you have
used for the installation of the S10V IR.LINK system, the installed program may
be missing from the program menu displayed. In this case, you should perform
the following series of steps: 1) make a logon again with the Administrator
account first created in the initial condition of your personal computer; 2) uninstall
the installed program; and 3) install the program again.
When you want to create a new account, be sure to make a logon with an
Administrator account. Do not use User Account Control at that time.
(*) User Account Control is a Microsoft Windows feature that temporarily grants
administrative rights to standard user accounts.
A message reporting a read-only file detected may be displayed during the reinstallation of the
S10V IR.LINK system. In this case, click the Yes button to set off overwriting.