■
Precautions concerning installation location
●
Install a short circuit breaker or safety breaker in conjunction with commercial power
supply.
●
Install the equipment where it is not exposed to dust, dirt and pieces of metal.
●
Install in a location where it will not come into contact with water and oil.
●
Do not place or stack heavy objects on top of this equipment.
●
Install this equipment in a stable location that will not cause vibration.
●
For installation in a high location, fix the equipment firmly to exclude the risk of falling.
●
Do not install near high voltage equipment or in noisy environments.
●
Do not make input or output wires longer than necessary, and do not bundle with
power supply wiring. This may cause a malfunction.
■
Precautions during use
●
Connect the equipment to ground and operate at the rated power supply voltage.
●
When connecting loads to the output terminals on the terminal block on the rear panel,
do not exceed the rated load. Exceeding the rated load may cause a failure.
●
If an external device connected to the +24V DC output or other input or output termi-
nals on the terminal block on the rear panel is affected by electromagnetic induction
effects, such as a relay or a coil for an electromagnetic valve, use noise countermea-
sures such as diodes for absorbing reverse voltage. If noise countermeasures are not
used, this may be the cause of malfunction or failure.
●
Do not connect the +24V DC terminal to any of the output terminals (COMP, VALVE,
BZ, ER BZ) or ground terminals on the terminal block on the rear panel.
This con-
nection will cause failure of the unit.
●
Do not connect the +24V DC terminal to any of the input terminals (RESET, SET) of
the terminal block on the rear panel.
This connection will cause failure of the unit.
●
When using the functions of the equipment for external equipment with an external
power supply, make the ground terminals common. If ground terminals are not com-
mon, this may cause malfunction or failure.
●
Do not apply voltage to the input terminals or output terminals. Connection to voltage
may cause a failure.
●
Do not change For/Rev SW while your running the screwdriver by either pressing
Lever SW, for Lever start type, or pushing the screwdriver, for Push start type.
It may cause either wrong count or damage internal SW of screwdriver.
When you change For/Rev SW, stop pressing the Lever or stop pushing the screw-
driver and wait until motor stops.
●
Use in a temperature range from 5
℃
- 40
℃
and at a humidity of less than 80% (free
from condensation).
●
Hold the plug when attaching or removing a power cord or screwdriver cord.
●
Do not drag the cords or allow them to come into contact with oil or sharp edges, etc.,
or to come underneath heavy objects. This may cause a break or failure.
●
If the electric screwdriver locks up, or if there is an overload, the overload protection
function operates. If the overload protection operates several times, it may be because
- 3 -
Summary of Contents for BLOP-STC 3
Page 14: ...Function Setting Table 13...
