(Setting range from 0.01 second to 0.99 second)
The buzzer will sound for a short time if a torque-up operation is performed after the
count timer has expired.
While variations between different operators may exist, perform continuous confirma-
tion tightening before setting the time required for work without using a count-down.
(The factory setting for the count timer is 0.15 second)
•
When settings have been completed, press the F1 switch to move to the next setting.
•
When all settings have been completed, press the F1 switch for 1 second or more. The
buzzer will sound twice, and the setting mode will close.
<Caution>
•
Countdown will not be performed if a count timer operating time longer than the actual
time required for tightening has been set. Take note of this when tightening screws with
a short thread.
4) Reverse Counter Timer Settings - for BL
•
Change to the Reverse Counter Timer Setting mode (F1 Display " "), loosen the
screw, and set the reverse time of the electric screwdriver using the x10, x1 switches at
the point where the screw has been determined to be removed.
(Setting range is from 0.1 second to 1.0 second. The factory setting for the reverse
counter timer is 0.2 second)
•
When settings have been completed, press the F1 switch to move to the next setting.
•
When all settings have been completed, press the F1 switch for 1 second or more. The
buzzer will sound twice and the setting mode will close.
<Caution>
•
Releasing the start lever after 0.1 second has elapsed for short threaded screws that
are removed in less than 0.1 second of starting reverse rotation can increase the count-
up by 1.
•
Using the screwdriver in the reverse rotation for longer than the time set in the reverse
counter timer will increase the count-up by 1, even if the screw is not actually loosened.
5) Settings for the Work Reset Timer
•
Change to the Work Reset Timer Setting mode (F1 Display " ") and set the work reset
timer operating time using the x10, x1 switches.
•
After the torque-up operation is complete for the final screw on the current work piece,
set the Work Reset Timer to the time taken for the DRV LED (operating display) to
change from orange to green for the current work piece.
•
The output of the VALVE signal is stopped when the Work Reset Timer operation is
complete.
•
After the Work Reset Timer operation has stopped, the COMP signal will be generated
for 0.1 second.
•
When settings have been completed, press the F1 switch to move to the next setting.
•
When all settings have been completed, press the F1 switch for 1 second or more. The
- 15 -
Summary of Contents for BLOP-STC 3
Page 14: ...Function Setting Table 13...
