Hioki MR8904, Instruction Manual

Page: 50 / 72

5.6 Sending and Receiving Condition Settings
46
This section describes how to send settings to the Memory HiCorder after saving a condition settings file.
5.6 Sending and Receiving Condition Settings
Sending condition settings
1
Click [Send] .
The dialog box shown to the right will be displayed
when the transmission starts properly.
When the transmission completes, the dialog box to
the right will be displayed.
2
Click [OK] .
If the unit is unable to send the data for some rea-
son, the message to the right will be displayed. This
message indicates that the unit was unable to con-
nect to the port attempting to send or receive the
settings.
See:
An error is displayed.: "8.1 Troubleshooting"
(p.63)
If no response is received from the Memory HiCord-
er for some reason, the message to the right will be
displayed. Resend the settings. If the error persists,
restart the Memory HiCorder and then resend the
settings.
If the message shown to the right is displayed, there
may be an illegal value in a definition registered in
the register list. Refer to p.26 and p.27 and remove
the illegal definition.