Hioki MR8904, Instruction Manual

Page: 47 / 72

5.4 Creating Condition Settings Files
43
* A system of numerical notation based on the number 16. The 10 digits represent the numbers 0
through 9, while the letters A, B, C, D, E, and F are used for the decimal numbers 10, 11, 12, 13,
14, and 15.
3
Click [OK] to accept the settings.
The dialog box will close.
(You can click [Cancel] to close the dialog box without adding the definition.)
Setting Contents (

Default setting)
ActMode
One Shot : Sends one message only.
Response : Sends responses to the ID set with [RespID] . Re-
sponses are sent as soon as the set ID is received, and
no delay time before frame transmission can be set.
Interval* : Sends messages regularly at the interval set with [In-
terval] .
One Shot Program : Sends messages tagged for [One Shot Program] one
at a time, starting with the lowest number and proceed-
ing in order until each has been sent once. The interval
between the transmission of one program and the next
is set with [Interval] .
Repeat Program : Repeatedly sends messages tagged for [Repeat Pro-
gram] in order, starting with the lowest number. The in-
terval between the transmission of one program and
the next is set with [Interval] .
Port1 / Port2
Selects the CAN port with which to send the frame.
FrmType
Data frame* : Sends a data frame.
Remote frame: Sends a remote frame.
SendID
Sets the frame ID to use to send the set content as a hexadecimal value.
(Valid setting range: 1 to 1FFFFFFF)
Len
Enter the byte length of the frame to send. (Valid setting range: 0 to 8)
SendText
Enter the text to send with the [SendID] frame as a hexadecimal value.
Input boxes for the length specified with [Len] will be displayed, and one
byte of data should be entered into each.
(For example, if [Len] is 4, 01 45 AB EF.)
RespID
The set frame will be sent when a port with the message ID (hexadecimal*)
set here is received.
This setting is valid when [ActMode] is set to [Response] .
(Valid setting range: 1 to 1FFFFFFF)
Interval
Sets the interval at which to send the frame ID set here as a multiple of 10
ms. This setting is valid only when [ActMode] is [Interval] , [One Shot Pro-
gram] , or [Repeat Program] .
(Valid setting range: 1 to 9,999 [X 10 ms])
Since it is not possible to send and receive data simultaneously, when allocating a definition
with the same ID as the transmit frame to be received by the same port as used for trans-
mission, the set transmit frame will not affect measured values.