24
English
2238935
*2238935*
WARNING
Risk of injury!
Risk of injury if the pulley stand falls!
▶
Use only anchors suitable for the base material to secure the pulley stands. Comply
with the instructions for use in the operating instructions of the anchor.
1. Mark the position of the anchor hole for the pulley stand.
2. Drill the anchor hole and clean it out.
3. Insert the anchor in the hole and use the setting tool to expand the anchor.
4. Screw in the clamping spindle as far as it will go and then back off the clamping
spindle 1 full turn.
5. Fully back off the 4 leveling screws on the pulley stand.
6. Set the pulley stand on the clamping spindle and bring it into correct alignment.
7. Screw the clamping nut on to the clamping spindle and tighten it firmly with an
open-ended wrench
(I)
.
8. Tighten the leveling screws evenly until the pulley stand is upright and firmly seated
on the surface
(II)
.
9. Position the wire guide unit with clamp on the stand and bring the wire guide unit into
correct alignment.
10.Tighten the clamping screw for the wire guide unit firmly with an open-ended wrench
(III)
.
7.1.5 Connecting the electricity supply, water and compressed air
Make sure that the main switch is set to
OFF
and that the
EMERGENCY STOP
button
has been pressed.
The cooling-water valves are open when the drive unit is switched off. If you want to
interrupt the flow of cooling water with the drive unit switched off, close the cooling-
water valves by hand.
Summary of Contents for DSW 1510-CA
