34
English
2238935
*2238935*
3. Move the piston to make sure that you also clean the areas of the piston rod covered
by the guide bearings.
4. Connect the tube of the grease gun to the grease nipple.
5. Inject grease into the 2 grease nipples.
Continue injecting grease until the grease squeezes out at the piston rods. In this
way you clean the bearings.
6. Lubricate the guide pulleys on the drive unit and the pulley stands.
9.4 Replacing rubber-tired pulleys on the DSW-SPP 240 single-pulley stand
1. Remove the pulley.
2. Remove the worn sealing rings (2 of)
(1)
.
3. Remove the ball bearings by using a suitable tool to press out the ball bearings from
the inside toward the outside
(2)
.
4. Press in the new ball bearings
(3)
.
Before pressing them in, check each ball bearing to ensure that it is a correct fit.
Seat the press-in tool only against the outside ring of the ball bearing .
5. Press in the new sealing rings.
6. Lubricate the sealing rings with grease.
7. Use a suitable screwdriver to slacken the screws (8 TX 45 screws) of the locating ring.
8. Remove the worn rubber tire.
9. Clean the contact faces of the tire carrier and the locating ring.
10.Install the new tire and the locating ring.
Summary of Contents for DSW 1510-CA
