Hill-Rom Primo P02033, User Manual

Page: 46 / 398

PROPRIETARY AND CONFIDENTIAL DRAFT: octobre 11, 2012
Page 40 170924(2) - EN - Primo
™
User Manual
Recommended separation distances
*:Effective Radiated Power
Voltage dips,
brief outages
and variations
in voltage on
the electric
power supply
lines
IEC 61000-4-
11
• <5% U
T
a
(dips >95% of U
T
)
for 0.5 cycle
• 40% U
T
(dips = 60% of U
T
)
for 5 cycles
• 70% U
T
(dips = 30% of U
T
)
for 25 cycles
• <5% U
T
(dips >95% of U
T
)
for 5 seconds
• <5% U
T
(dips >95% of U
T
)
for 0.5 cycle
• 40% U
T
(dips = 60% of U
T
)
for 5 cycles
• 70% U
T
(dips = 30% of U
T
)
for 25 cycles
• <5% U
T
(dips >95% of U
T
)
for 5 seconds
The quality of the electric power
supply should be the equivalent of
that found in commercial or hospital
environments.
If the user of the Primo
™
requires the
appliance to be in continuous use
during power cuts, it is advisable to
power the Primo
™
from an
uninterruptible power source or a
battery.
a. U
T
is the nominal value of the supply voltage applied during the test.
RF communication equipment (including peripherals such as antenna cables and external
antennas) should be used no closer to any part of the Primo
™
, including cables specified by
Hill-Rom , than the recommended separation distances shown in the following table.
Otherwise, degradation of the performance of this equipment could result.
Wireless communication system
Separation distance
(m)
TETRA 400 (limited to 10 W ERP*) 0,3
Public safety(460-470 MHz), GMRS 460 (limited to 5 W ERP*) 0,2
GMRS 460 (limitede to 2 W ERP*) 0,1
GSM 850, GSM 900, RFID 868 MHz, TETRA 800 (limited to 2 W
ERP*)
0,3
GSM 1900 (limited to 1 W ERP*) 0,2
WLAN 802.11a 5 GHz (limited to 1W ERP*) 0,7
iDEN 820, CDMA 850, GSM 1800, CDMA 1900 (limited to 0,6 W
ERP*)
0,2
FRS 460 (limited to 0,6 W ERP*), PMR 446 0,1
UMTS, DECT (limited to 0.25 W ERP*) 0,1
Manufacturer's recommendations and declaration – electromagnetic immunity
The Primo
™
is intended for use in the electromagnetic environment specified below. The customer or
the user of the Primo
™
should make sure it is used in such an environment.
Immunity test
Test level
IEC 60601
Compliance
Electromagnetic environment -
Recommendations