Hilberling PT-8000, Operating Manual

Page: 54 / 82

C–44
Part C Installation And Operation
When activating RIT/XIT the last used status (RIT or XIT) will be selected.
Pushing RIT/XIT again will terminate the RIT/XIT function.
To adjust the offset frequency turn the knob called CLAR (clarifier) located
next to the cluster VFO.
The tuning increments of the CLAR control is identical to the selected STEP
rate.
RIT/XIT are not available for SUB-RX.
In case the SUB-RX is the active oneXIT/RIT and the offset are no longer
displayed.
In case the SUB-RX is the active one and XIT is activated for the MAIN-RX,
pushing PTT will display the MAIN-RX as the active one. XIT and the offset
are indicated.
If the RIT/XIT softkey menu is displayed pushing RIT/XIT will terminate this
modus. If the menu is not displayed pushing RIT/XIT will call it up and a
second push will terminate ROT/XIT operation.
The RIT/XIT-LED will extinguish.
Changing MODE will always terminate RIT/XIT operation
11.9 LOCK Function
All controls that will have an effect on the frequency selected can be locked
through pushing LOCK which is located in the cluster VFO.
Engaging LOCK will turn its LED on
The following controls (knobs, buttons) are effected by LOCK:
•
MAIN-RX VFO
•
SUB-RX VFO
•
STEP-VFO
•
BAND
•
CHANNEL / MEM
•
RIT / XIT
Termination of
RIT/XIT operation
Pi t 53
Picture 54