Hilberling PT-8000, Operating Manual

Page: 64 / 82

C–54
Part C Installation And Operation
SCAN menu
Pushing the button SCAN located in cluster FUNCTION will activate scanning
of channels which are earmarked for scanning (see page C33). The receiver
will scan any frequency between 9 kHz and 29.999 MHz, and it will scan
frequencies from 50.0 to 54.0 MHz and 144.0 to 148.0 MHz.
These frequencies will be checked for a signal.
The RX will scan the channels from lower to higher frequencies with the
stored MODE and bandwidth.
•
If the squelch is engaged scanning will Stopp
when a signal on a scanned channel opens the
squelch
•
If the squelch is open, the RX will pause on the
scanned frequency for a time defined. After this
time has elapsed the scanning will continue.
•
If the squelch engages during the pause
scanning will continue immediately
Pushing SCAN will:
•
SCAN-LED will be on
•
The frequency of the standby VFO will
disappear. Instead information about the
scanned channel is displayed as in channel
modus (see page C33)
•
SCAN softkey menu will be called up
Delay time is 5 seconds
Delay time is 10 seconds
Delay time is 15 seconds
Delay time is 20 seconds
Delay time is 25 seconds
Delay time is infinite
Scanning will be terminated upon activating PTT, VFO tuning, STEP-VFO or
pushing SCAN. The frequency of the stanby VFO will reappear.
5 s
10 s
15 s
20 s
25 s
∞
Picture 74
Pi t 74