HIKVISION Pyronix EURO 46 V10, Programming Manual

Page: 37 / 64

37
EURO 46 V10 Programming Manual
Serial Connection (RS232)
The Control Panel is set up by the factory with the
RS232 port enabled as a method to connect to the
UDL software.
PLEASE NOTE:
For this connection a special cable
(that is supplied by Pyronix) is required, or it can be
created according to the diagram on the right.
PLEASE NOTE:
If the PC does not have a serial
port, you may require a standard RS-232 to USB
converter.
Unscrew and open the Control Panel’s casing and
plug the RS-232 cable into the dedicated connector.
On the Panel
1. Enter the Engineer Menu.
2. Scroll the menu until on ‘Set Up Downloading’ - Press
 .
3. Choose ‘RS-232’ in the ‘Download by’ option - Press

.
4. Now on the ‘UDL Password’ screen – optional – can be left blank or entered, then press ‘

’
5. Now on the ‘Site Name’ screen – compulsory – enter a site name and make sure you take note of
it (for use later in the Insite software) – Press

.
6. Finally go out of this menu and then into the ‘Site Options’ main menu and then scroll through
until ‘Cloud Priority’, set this to ‘Normal’ for initial connections and then press

(ensure
that if this setting is put back to high for ungraded systems – or leave it as ‘normal’ on graded
systems).
On InSite UDL software from a PC
1. To set up the COM port associated to ‘modem’, open the software, click on ‘Configuration’,
choose ‘Modem Settings’ and select the ‘RS-232’ option
2. Make sure that the serial COM used by the UDL software is set the same as in your PC. E.g.
Control Panel -> Device Manager -> Ports (Typical Windows PC).
3. Make sure that the RS-232 icon (at the bottom of the screen) has turned green.
4. Click on ‘Roving Dial customer’.
5. Set the ‘Dial Out Mode’ field to ‘RS-232’.
6. Enter the Engineer code in the ‘Engineer Code’ field.
7. Enter the site name as entered in the panel (case sensitive).
8. Click on ‘Dial’
9. If the connection is successful, the RS-232 icon will become blue