User Manual of Network Mini PTZ Camera
© Hikvision
32
3.
Check on the Wi-Fi router to see if there is a WPS button. If yes push the button
and you can see the indicator near the button start flashing, which means the
WPS function of the router is enabled. For detailed operation, please see the
user guide of the router.
4.
Push the WPS button to enable the function on the camera.
If there is not a WPS button on the camera, you can also click the virtual button
to enable the PBC function on the web interface.
5.
Click
Connect
button.
When the PBC mode is both enabled in the router and the camera, the camera
and the wireless network is connected automatically.
PIN Mode:
The PIN mode requires a Personal Identification Number (PIN) to be read from either
a sticker or the display on the new wireless device. This PIN must then be entered to
connect the network, usually the Access Point of the network.
Steps:
1.
Choose a wireless connection on the list and the SSID is shown.
Figure 4-10
Wi-Fi Settings – WPS PIN Mode
2.
Choose
Use route PIN code
.
If the PIN code is generated from the router side, you should enter the PIN code
you get from the router side in the
Router PIN code
field.
3.
Click
Connect
.
Or
You can generate the PIN code on the camera side. And the expired time for the PIN
code is 120 seconds.
1.
Click
Generate
.
2.
Enter the code to the router, in the example, enter 70137231 to the router.
4.3
IP
Property Settings for Wireless Network
Connection
The default IP address of wireless network interface controller is 192.168.1.64. When
