HighLine Bale Pro CFR650, Operator'S Manual

Page: 42 / 65

Section 4 - Operating the CFR 650
Windrow Feeding
201215
2. Set the speed of the feed rollers.
Adjust the feed roller speed to a
maximum of 40 rpm.
- Adjust using the tractor flow control
settings.
- Faster feed roller speeds will result in
a faster discharge of material.
Note: Running the feed rollers too
fast may cause the feed rollers
to dig into the bale to the point
where the bale will no longer
be turned in the tub.
- Slower feed roller speeds will result in
a slower discharge of material.
3. Set the upper deflector door.
- Raise or lower the upper deflector
door to adjust the amount of
spreading of material.
-
Use the hydraulic cylinder to adjust
the door.
Lowered - the material will be left in a
windrow or directed into a feed bunk.
-
Allow the rubber deflector to hang
down.
Midway - deflector door will control the
height and distance of discharged
material.
-
Place the rubber deflector into the
tabs on the door.
Raised - material will be spread out
over a wide area - such as for bedding
materials.
-
Place the rubber deflector into the
tabs on the door.
Set Feed Roller Speed
201214
Set the Upper Deflector Door
201216
Page 4-3