Section 4 - Operating the CFR 650
Discharge Rate Settings
There are 2 settings that determine the
discharge rate of material:
-
The aggression level of the flails
acting on the bale.
-
The speed of the feed rollers which
feed the bale into the flail drum.
1. Set the aggression level of the flails.
Adjusting the aggression level is done
with the guard rod adjustment handle.
The bale rests on the guard rods. The
amount of contact between the bale and
the flails is determined by the guard rod
setting.
There are five guard rod settings.
-
Pull the upper handle out of the
handle lock.
-
Raise or lower the handle to the
desired discharge setting.
-
Lock the handle in the notch.
To Increase the discharge rate:
- Raise the handle to a higher number.
To Decrease the discharge rate:
- Lower the handle to a lower number.
If the Hydraulic Aggression Control Option is
installed:
-
Activate the hydraulic cylinder to
change the position of the guard rods.
To Increase the discharge rate:
- Raise the pointer to a higher number.
To Decrease the discharge rate:
- Lower the pointer to a lower number.
Set the Aggression Level of the Flails
214087-2
Hydraulic Aggression Control Option
212112-2
Page 4-2
Summary of Contents for Bale Pro CFR650
