HighLine Bale Pro CFR650, Operator'S Manual

Page: 43 / 65

Section 4 - Operating the CFR 650
4. Set the lower deflector door.
- Raise or lower the lower deflector
door to adjust the discharge height
and distance of material.
- To Increase height and distance,
move the door up.
- To decrease height and distance,
move the door down.
5. Load the bale into the processor tub.
- Align center of bale with the center of
the processor.
- Lower the forks completely.
- Slowly back up to the bale until the
forks are completely under the bale.
- Raise the forks enough to lift the bale
off the ground.
Note: If a bale is frozen to the ground,
dislodge it by rocking the machine
to impact the bale and loosen it.
Note: Ensure flail drum and feed rollers
are not turning while loading a
bale.
- Raise the lift forks until the bale falls
into the processor.
Set the Lower Deflector Door
214087-2
Align Bale to be Loaded
201218
Raise Bale into Processor Tub
201219
Page 4-4