Hi-Tech Solutions C5, Installation And Operation Manual

Page: 44 / 71

42 Viewing and Changing Remote Camera Parameters
Viewing and Changing Remote Camera
Parameters
The remote camera is the secondary camera in a dual-camera installation.
The option for dual-camera enclosure is not currently supported.
f
To view and change remote camera parameters:
1. In the C5 Portal home page, click Configure .
The Configure page appears.
2. In the Remote Camera section, view or change the settings, as described in Viewing
and Changing Local Camera Parameters . The only difference is that the Enabled
checkbox refers to the remote camera, not the local camera.
Viewing and Changing Network Client
Parameters
f
To view and change C5 network client parameters:
1. In the C5 Portal home page, click Configure .
The Configure page appears.
2. In the Net Client section, view or change the settings, as described in the table below.
Figure 27: Configure Page – Net Client Parameters
Parameter Description
Enabled
If this option is selected, the result and the best image will be sent
to the SeeData application on a PC/laptop connected to the same
network.
ServerIP The IP address of the PC/laptop that runs the SeeData application.
Port The TCP/IP port to connect to the PC/laptop.
In the case of changing network parameters (IP address) the whole
system must be restarted and it will cause current portal session
disconnection
.