EN
82/83
Message / fault
Cause
Remedy
SENSOR-ERROR
90
Error / defect electronics
SENSOR-ERROR
91 - 93
Error / defect unbalance sensor
Perform a MAINS RESET.
NO ROTOR OR
ROTORCODE
ERROR
---
No rotor installed.
Faulty speedometer.
Open lid.
Install rotor.
Speed in the selected program greater than
the maximum speed of the rotor.
Check the set speed.
Reduce the set speed
N
ROTOR MAX
---
The rotor has been changed. The
maximum speed of the installed rotor is
higher than that of the rotor that was
previously used and this has not yet been
detected by rotor recognition.
Set a speed up to the maximum
speed of the rotor that was
previously used. Press the
START
key to run rotor
recognition. See chapter, "Rotor
Recognition".
There is a program in the displayed
program location whose speed is higher
than the maximum speed of the rotor.
Check the set speed.
Reduce the set speed
N > ROTOR MAX
in Prog : e.g. 3
---
The rotor has been changed. The
maximum speed of the installed rotor is
higher than that of the rotor that was
previously used and this has not yet been
detected by rotor recognition.
Set a speed up to the maximum
speed of the rotor that was
previously used. Press the
START
key to run rotor
recognition. See chapter, "Rotor
Recognition".
Runtime 00:00
in Prog : e.g. 3
---
There is a continuous operation program in
the displayed program location.
Replace the continuous operation
program in the program linkage
with a program with preset time.
Empty Program
---
There is no program linkage saved on the
displayed program location.
Call up a program linkage.
Ramp Unit Time in
Prog : e.g. 3
---
A program with start-up and/or run-down
time is located at the displayed program
place.
Replace the program in the
program link with a program with
start-up and braking stage.
Acc time > Run time
---
The set start-up time is longer than the run
time.
Set a start-up time which is
shorter than the run time.
FC INIT ERROR
---
Error / defect electronics
FC VERSION ERROR
---
Error / defect electronics
FATAL EEPROM
ERROR
1 - 5
Error / defect electronics
WATCHDOG RESET
Error / defect electronics
Perform a MAINS RESET.
