EN
72/83
28
Displayed centrifugation data after switch-on.
After switch-on the centrifugation data from program 1, or from the last program that was used, is displayed.
If the rotor is at standstill, this can be set as follows:
The setting can only be made via the operating unit (key position "0" or "LOCK 2"). The functions of the
various key positions are described in the "Key-operated switch" chapter.
You can scroll backwards through the menu by pressing the
T/°C
key.
The operation can be cancelled at any time by pressing the
OPEN / STOP
key. In this case, the settings are not
stored.
Keep the
PROG
key held down for 8 seconds.
After 8 seconds,
Machine Menu
appears in the display.
Press the
PROG
key as often as necessary until the
->Settings
is displayed.
Press the
START
key. The
SOUND / BELL = off/on
is displayed.
Press the
PROG
key as often as necessary until
Start program = Last/First
is displayed.
Use the adjusting knob to set
Last
or
First
.
Last = the program used last, First = program 1.
Press the
START
key to save the setting.
Briefly,
Store Settings ...
is displayed as confirmation, followed by
-> Settings
.
Press the
OPEN / STOP
key once to exit the "Settings" menu or press the
OPEN / STOP
key twice to exit the
"Machine Menu".
29
Set temperature unit
The temperature can be entered in degrees Celsius (°C) or in degrees Fahrenheit (°F).
When the rotor is at standstill, the temperature unit must be set as follows:
The setting can only be made via the operating unit (key position "0" or "LOCK 2"). The functions of the
various key positions are described in the "Key-operated switch" chapter.
You can scroll backwards through the menu by pressing the
T/°C
key.
The operation can be cancelled at any time by pressing the
OPEN / STOP
key. In this case, the settings are not
stored.
Keep the
PROG
key held down for 8 seconds.
After 8 seconds,
Machine Menu
appears in the display.
Press the
PROG
key as often as necessary until the
->Settings
is displayed.
Press the
START
key. The
SOUND / BELL = off/on
is displayed.
Press the
PROG
key as often as necessary until
Temp Unit = Celsius/Fahrenheit
is displayed.
Use the adjusting knob to set
Celsius
or
Fahrenheit
.
Press the
START
key to save the setting.
Briefly,
Store Settings ...
is displayed as confirmation, followed by
-> Settings
.
Press the
OPEN / STOP
key once to exit the "Settings" menu or press the
OPEN / STOP
key twice to exit the
"Machine Menu".
30 Centrifuge
address
Ex works, the address is ] = 29. Address is set.
