en
12.2020 / Rev. 02
AB66005
74 / 174
Operation
Fig. 102: ‘Program segment settings
Start date’
1 Start date
Fig. 103: ‘Program segment settings
Start date
Date selection’
1
[Confirmation] button
2 Date selection
3
[Cancel] button
Item
Designation
Description/function
7
Set temperature
You can change the temperature setpoint for this program
segment in steps of 0.1 with the
[Plus] and [Minus] buttons.
By tapping on the temperature, a dialogue opens, via which
you can enter the temperature setpoint directly.
If a
‘-’ is given for the temperature setpoint, the incubator is
at a standstill during this time. A standstill segment is indi-
cated with a
‘-’ in the segment overview. A standstill seg-
ment makes sense for a program repetition.
Chapter 6.8.1 ‘Functional description of standstill mode’
The temperatures can also be input outside the limits
of the temperature guard. This is not checked.
Please note that at the start of the program, the
input temperatures are compared with the tempera-
ture guard limits. If these were exceeded, a warning
message will be output
To input a start time (can only be set for the first segment), proceed
as follows:
1.
Tap on the start date.
The start time specified her is only for calcu-
lating the duration. The actual start time results
from the start of the created program or by the
activation of the timer
2.
Tap on the desired date and confirm the selection with the
[Confirmation] button.
You will go back to the
‘Program segment settings’ menu.
Summary of Contents for HettCube 200
