TW-800R-SCL/TW-800T
35
●
Drawing with TW-SCLF01 installed
■14.Troubleshooting
TW-800T
(
Transmitter
)
Phenomenon
Cause and remedy
The transmitter does not transmit
LED (red or green) does not light up
Battery capacity is low.
→Please replace the battery
(
CR2032
)
.
The limit switch signal is not connected.
→Make sure the connector of the transmitter board and the
limit switch connector are securely connected.
The limit switch is not hit.
→Adjust the installation position of the limit switch on the
torque wrench body and check if the limit switch is hit.
The red LED blinks 3 times after transmitting.
Pairing is not done. (not registered)
→Perform pairing with the receiver to communicate with the
transmitter.