TW-800R-SCL/TW-800T
28
10-3.Confirmation of the connection status with the application
When the receiver is set to the application interlock mode, the connection status with POKAYOKE plus is
indicated by lighting or blinking of the network monitor (blue) and 7 SEG-LED.
・
Lit: Communicating with POKAYOKE plus
・
Blink: Communication with POKAYOKE plus is disconnected
When the receiver receives a signal from the transmitter in the
communication disconnected state, the buzzer sounds.
The buzzer is stopped by pressing the [RESET] key or by an external input.
When the network monitor is blinking, the possible cause is as follows.
・
The LAN cable is disconnected.
・
POKAYOKE plus does not start up.
・
The IP address/Port No. was not correctly set for receiver registration on POKAYOKE plus.
10-4.Operation
When using the receiver with POKAYOKE plus, perform various settings, such as work registration, on
POKAYOKE plus.
Task instructions (control of the count display, buzzer, external output, etc.) are provided by POKAYOKE plus.
The receiver runs according to the instructions.
When the receiver receives a signal from the transmitter, the signal is transmitted to POKAYOKE plus.
POKAYOKE plus changes the count value and transmits the display change instructions to the receiver.
When a judge or reset instruction is provided from an external input to the receiver, the receiver informs
POKAYOKE plus of the instruction.
For details, refer to "POKAYOKE plus Instruction Manual".
Network monitor
Transmit the signal received from the transmitter
Transmit the task instruction
Transmit the display change instructions
Transmit the external input (Judge/Reset)
Transmit a judge output instruction
