TW-800R-SCL/TW-800T
12
<The attention and the check method on limit switch attachment>
When the lever working range of a torque wrench is small, a limit switch cannot be struck and a transmitter may
not send. In limit switch attachment, be careful enough and carry out.
<Installing and removing the battery>
●Installing the battery
First, with the “positive (+) terminal” of the coin battery (CR2032) facing up, insert the battery into the gold plated
terminal of the battery holder , as shown in Fig. 1 below.
Push the battery so that it is secured by two catches in the plastic part of the battery holder until the battery snaps
into place.
●Removing the battery
When removing the coin battery for replacement or other reasons, slide a not sharp-edged object between the
battery and battery holder and gently lift the bottom of the battery, as shown in Fig. 1 below. As shown in Fig. 2
below, the battery can be slid out of the battery holder through the tab of the gold
–plated terminal.
Gold plated terminal
①
②
①
②
Two catches in the
plastic part
(Notes!)
Be sure to insert the battery into the gold
plated terminal first. Inserting the battery into
the plastic part first may damage the gold
plated terminal.
The battery is slid out of the holder through the tab of
the gold
–plated terminal.
(Notes!)
Care should be taken not to disconnect the limit switch cable of TW-800T while installing or
removing the battery. It is advised to remove the limit switch cable from the connector before
installing or removing the battery.
