Henny Penny EVOLUTION ELITE EEE-181, Technical Manual

Page: 8 / 118

Model EEE-182
1-4
Problem Cause Correction
Oil foaming or boiling
over top of vat
• Water in oil
• Improper or bad oil
• Improper filtering
• Improper rinsing after
cleaning the vat
• Drain and clean oil
• Use recommended oil
• Refer to filtering procedures
• Clean and rinse vat and then
dry thoroughly
Oil will not drain from vat • Drain valve clogged
with crumbs
• Drain trough clogged
• Open valve, force cleaning
brush through drain
• Remove right side panel and
remove plug from end of
trough and clean trough
Filter motor runs but
pumps oil slowly
• Filter line connections
loose
• Filter paper or pad
clogged
• Tighten all filter line
connections
• Change filter paper or pad
Bubbles in oil during
entire filtering process
• Filter pan not
completely engaged
• Filter pan clogged
• Damaged O-ring on
filter line receiver on
fryer
• Make sure filter pan return line
is pushed completely into the
receiver on the fryer
• Clean pan and change paper or
pad Change O-ring
Control error code “E-31” • Elements are up • Lower elements back into vat
Filter motor will not run • Power cord for vat #1 is
not plugged-in
• Open circuit
• the thermal reset button
on the rear of the pump
motor is tripped
• Plug power cord into
receptacle
• Breakers in fryer tripped; open
left door and reset breaker on
fryer
• Allow time for the motor
to cool and then, using a
screwdriver, press hard against
the button until it clicks
July 2016