Henny Penny EVOLUTION ELITE EEE-181, Technical Manual

Page: 62 / 118

Model EEE-182
6-20
This pump keeps the vats filled and is used in the Oil Guard-
ian™ process.
Replacement
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Remove the right side panel.
2. Using a 1” wrench, loosen fitting on right side of pump.
3. Remove the hose from the pump.
4. Remove the 4 bolts securing the bottom of pump.
5. Disconnect the wires in the rear of the pump and pull
assembly from fryer.
6. Pull fittings from faulty pump and attach the fittings to the
new pump, in the same orientation.
7. Install new pump assembly in fryer, in reverse order and
then reconnect power to fryer.
This electronic board controls the Automatic Intermittent Fil-
tering process.
Replacement
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Hinge-down the center control panel (right panel on 2 vat
units).
2. Pull connectors from PC board, located behind control
panel.
3. Using a 5/16” socket, remove the 6 nuts securing the board
and remove it from the fryer.
4. Install in reverse order. The control connectors are colored-
coded; Left-Red; Middle-White; Right-Blue.
6-14. JIB PUMP
6-15. EXPRESS FILTER PC
BOARD
July 2016