Henny Penny EVOLUTION ELITE EEE-181, Technical Manual

Page: 11 / 118

Model EEE-182
1-7
1-4. ERROR CODES (Continued)
DISPLAY CAUSE CORRECTION
“E-21” Slow heat recovery Have a certified service technician check the fryer for correct
voltage to the unit; have the contactors and heating element
checked; have unit checked for loose or burnt wires
“ E-31” Elements are up Lower elements back into the vat
“E-41”, “E-46” Programming Turn switch to OFF, then back to ON; if display shows any
failure of these error codes, have the controls re-initialized; if error
code persists, have the control board replaced
“E-47” Analog converter Turn switch to OFF, then back to ON; if “E-47” persists,
chip or 12 volt have the I/O board, or the PC board replaced; if speaker
supply failure tones are quiet, probably I/O board failure; have the I/O
board replaced
“E-48” Input system Turn switch to OFF, then back to ON; have control PC board
error replaced if “E-48” persists
“E-54C” Temperature input Turn switch to OFF, then back to ON; have control PC board
error replaced if “E-54C” persists
“E-60” AIF PC board not Turn switch to OFF, then back to ON; if “E-60” persists,
communicating have the 1.5 amp fuse on the AIF PC board checked;
with control PC have the connector between the PC boards checked;
board replace AIF PC board or control PC board if necessary
“E-93-A” Auto lift motor If auto lift feature is not operating, have each of the
“24 VDC” malfunction auto lift motors checked.
“SUPPLY or failure
TRIPPED”
July 2016