Henny Penny EVOLUTION ELITE EEE-181, Technical Manual

Page: 10 / 118

Model EEE-182
1-6
1-4. ERROR CODES
In the event of a control system failure, the digital display
shows an error message. The message codes are shown in the
DISPLAY column below. A constant tone is heard when an er-
ror code is displayed, and to silence this tone, press any button.
DISPLAY CAUSE CORRECTION
“E-4” Control board overheating Turn switch to OFF position, then turn
switch back to ON; if display shows “E-4”,
the control board is getting too hot; check
the louvers on each side of the unit for
obstructions
“E-5” Oil overheating Turn switch to OFF position, then turn switch
back to ON; if display shows “E-5”, the
heating circuits and temperature probe should
be checked
“E-6A” Temperature probe open Turn switch to OFF position, then turn switch
back to ON; if display shows “E-6A”, the
temperature probe should be checked
“E-6B” Temperature probe shorted Turn switch to OFF position, then turn switch
back to ON; if display shows “E-6B”, the
temperature probe should be checked
“E-10” High limit Let unit cool down (15-20 minutes), press the
high limit reset switch located on the LH door.
If the high limit does not reset, high limit must
be replaced
“E-15” Drain Switch Make sure drain knob is completely pushed-in;
if E-15 persists, have drain switch checked
“E-18-A”
“E-18-B”
“E-18-C”
Left level sensor open
Right level sensor open
Both level sensors open
Turn switch to OFF position, then turn switch
back to ON; if display still indicates a failed
sensor, have the connections checked the
control board; have sensor checked & replaced
if necessory
July 2016