Operation 32
6.
Label Number
The label that was printed for this package.
7.
Number of Cycles
The number of cycles run from the start time.
6.3 Starting the Machine
1.
Plug in the machine.
2.
Turn the main switch to the ON position (see Electrical Installation on page 20) to turn on the
machine.
3.
Press the on/off button on the control panel to enable the operation.
In the 10-program control system, 3 dashes may be shown on the display during the first start-up
or ventilation. This means that the machine needs to be decompressed. In this case, open the lid
to decompress the machine.
6.4 Starting the Packaging Cycle
The machine must be started in accordance with Starting the Machine on page 32 before
starting a packaging cycle.
1.
Select the desired program.
10-program control system
Press the PROG 0 – 9 button.
ACS
Press the
►
button or the
▼
button.
2.
Put the product/products in place.
a.
Put the product/products in the vacuum bag.
b.
Place the vacuum bag in/on the vacuum chamber. Make sure the opening(s) is/are
correctly placed with regard to the seal position(s).
3.
Close the lid.
The packaging cycle will start.
6.5 Proceeding to the Next Step in the Cycle
For some products, it may be necessary to proceed to the next step in the packaging cycle before
the vacuum time or the vacuum level has been reached.
1.
Proceed to the next step in the cycle.
10-program control system
Press the + / VACUUM STOP button.
ACS
Press the
►
button.
The next step will be started.