Henden 8 Star, Installation & Owner'S Manual

Page: 14 / 20

Henden Bluetooth Enabled Variable Speed Pump Installation Manual
14 | HENDEN INSTALLATION & OWNERS MANUAL
NOTE NEVER knock the plastic
basket on a hard surface as it will
cause damage.
Failure to undertake regular
maintenance may cause damage
not covered by warranty.
Power supply to this pump needs to
be through an RCD, having a rated
leakage current not exceeding 30mA.
9. USING YOUR PUMP WITH A SALT
WATER CHLORINATOR
Chlorinators require a minimum flow rate through the
chlorinator cell for best efficiency and cell life. Please
refer to your chlorinator guide as a reference for the flow
required by your pool system.
Ensure flow rate is sufficient to cover your chlorinator cell
plates completely at all times of operation.
10. OPERATING YOUR SUCTION POOL
CLEANER
Before installing or purchasing a pool cleaner for use
with your Henden pool pump, it is important to know the
minimum flow rates required for it to operate effectively.
To operate a suction pool cleaner with your
Henden Variable Speed Pump:
1. Activate the High Flow setting (10) and allow the pump
to fully prime by running for around 2 minutes. You will
know the pump is primed when you can see a strong
flow of water through the clear leaf basket lid.
2. When all air is expelled from the leaf basket, connect
the pool cleaner hose firmly into the skimmer plate or
dedicated wall suction.
3. Select the speed setting that enables best performance
from your suction pool cleaner. Speed 3 to 7 should
be ample for most cleaners, however if the cleaner
requires better performance, select speeds 7 to 10.
4. The cleaner should only be connected for as long as
is required to clean the surface of your pool. When
cleaning is complete, disconnect the cleaner and
remove the skimmer plate from the skimmer box.
5. Reactivate the most efficient speed setting for daily
filtration. Speeds 1 to 4 is recommended.
11. MAINTENANCE: EMPTYING THE
STRAINER BASKET
The strainer basket should be inspected frequently
through the transparent lid and emptied when a build
up of rubbish is evident. The directions below should be
followed.
1. Switch off pump.
2. Unscrew the strainer basket lid anti-clockwise and
remove.
3. Remove the strainer basket by lifting upwards from its
housing.
4. Empty the trapped refuse from the basket. Hose out
with water if necessary.
5. Check the strainer basket for cracks, replace the
strainer basket in the pump if OK.
6. Replace the lid and ensure that it seals on the large
rubber o-ring. Firm hand tightness only is required.
The o-ring & thread can be lubricated with Hydra Slip
or equivalent products.
NOTE To get optimum energy
efficiency from your Henden Variable
Speed Pump DO NOT keep the suction
pool cleaner connected when cleaning
is not required.