Henden Bluetooth Enabled Variable Speed Pump Installation Manual
12
|
HENDEN
INSTALLATION & OWNERS MANUAL
• “External Timer Present”
> Swipe this on or off, depending on whether you are
using an external timer/chlorinator.
• Backwash
Can be set as a single speed or alternatively set two
speeds and the pump speed will “pulse” between the
two settings. Minimum speed can be set between 1-10,
maximum speed can only be set between 5-10.
• Priming Speed / Max Speed
Each time your pump starts it will go through 2 minutes
of priming to ensure there is water in the system. You
can adjust the speed in which it does this between 5 &
10. The speed you set will limit the maximum speed the
pump will run in manual or schedule mode.
• Disconnect Function
> The “disconnect from pump” function can be used to:
1. Allow another device to control the pump
2. Disconnect so that you will not automatically
connect to the pump.
> Please note that the Bluetooth connection will
automatically disconnect after a minute of no
communication
• “Factory Reset”
> This will reset the pump back to factory
configurations and allows you to start the set up
process again.
> Select “reset pump”
> Turn dial to “off” position, then turn dial to
“Bluetooth”
> You can then repair with your phone. This procedure is
in place so that the pump cannot accidentally be reset.
Note: App screenshots are for demonstration purposes only. Actual screens may vary.
8.4 Pump Fault Finding
In the instance that there is a
fault, the following screen will
appear, with text description
below the fault indicating how
to remedy.
Summary of Contents for 8 Star
Page 2: ......
Page 20: ...P N 403214 4...
