Eradicator Gen II O
3
Manual Supplement
Install & Service Guide
8
Copyright ©2021 Aqua Systems, All Rights Reserved • 404 Moravian Valley Road, Waunakee, WI 53597
Gen II O
3
with Ozone
Installation
On the circuit board, unplug the power plug (4-wire),
and the meter plug (3-wire) on the lower right side of the
board, then the motor plug on the lower left side of the
board. Carefully lift up slightly the tab holding the circuit
board in place, then gently pull the board forward, then
lift the board out.
Next, remove the drive bracket by gently lifting the two
tabs securing the the bracket and tilt it forward from the
tabs. The lower edge of the drive bracket has two notches
that rest on the drive back plate. Lift up and outward on
the drive bracket to disengage the notches.
Then, remove the power supply wire and transformer by
pushing/pulling it through the slot in the backplate.
Set the power supply and cord aside as it will not be
used in this application.
EOG II Wire Harness Assembly
Circuit board
locking tab
Drive bracket
locking tabs
Drive bracket
notches
Motor
Plug
Power
Plug
Meter
Plug
1.
2.
3.
