Eradicator Gen II O
3
Manual Supplement
Install & Service Guide
5
Copyright ©2021 Aqua Systems, All Rights Reserved • 404 Moravian Valley Road, Waunakee, WI 53597
Overview
Note: This section is an introduction to the EOG II components.
Details on components and wiring are found later in this guide.
Gen II O
3
with Ozone
The EOG II Ozone system is mounted on the inlet side of the control valve with the wire harness
going through the backplate to the circuit board. This allows the control valve and the O
3
system to
operate with a single power supply. An optional air dryer which increases O
3
production and quality
can be added to this control using the single power supply (see separate Air Dryer instruction sheet).
Gen II
EOG II
Wire Harness
Side View with
External Ozone
Air Intake
Filter Stone
When the control stops in the Regeneration DN position, air is pulled into the control through the
air intake . The air is pulled through a porous stone as a filter. The air is pulled through the Corona
Discharge (CD) Tube. When the tube is activated by the relay controlled power supply, it creates an
electrical arc internally. The air is passed through this arcing where it is converted from Oxygen (O
2
)
to Ozone (O
3
). The ozone then travels through the special tubing, through the check valve, and the
brine fitting,where it enters the filter system.
How Ozone is Produced
